Door Swing Dimensions; Stainless Steel Series Side Panels - Thermador T42BD820NS Installation Instructions Manual

Top View
Model
42" (106 cm)
48" (122 cm)
Front View
Width dimensions were measured from trim edge to trim
edge.
Height dimensions are shown with leveling legs extended
(3 mm) below the rollers.
A
(see chart following)
Model Width A (Trim edge to trim edge)
42" (106 cm) 42 " (107 cm)
48" (122 cm) 48 " (123 cm)
*When leveling legs are fully extended to 1 " (32 mm) below
rollers, add 1 " (29 mm) to the height dimensions.
A
25 "
(64 cm)
Width A
" (104 cm)
" (119 cm)
*83 "
(211.8 cm)

Door Swing Dimensions

The location must permit both doors to open to a minimum of
90°. Allow 4 " (11.4 cm) minimum space between the side of the
refrigerator and a corner wall.
To adjust the door swing, see "Adjust Doors."
42" (106 cm) Models
12 "
(32.1 cm)
37 "
(94.6 cm)
41 "
(105.1 cm)
90˚
110˚
130˚
"
48" (122 cm) Models
14 "
(36.5 cm)
39"
(99.1 cm)
43 "
(111.4 cm)
90˚
110˚
130˚

Stainless Steel Series Side Panels

Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
The dimensions shown are actual product dimensions
and may not reflect the needed panel installation
dimensions.
The side panel should be a minimum of ½" (1.27 cm) thick
to avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on rear wall.
41 "
(105.4 cm)
16 "
(42.9 cm)
47 "
(121.6 cm)
90˚
110˚
130˚
44"
(111.8 cm)
19 "
(48.9 cm)
51 "
(130.5 cm)
90˚
110˚
130˚
9