Gigabyte G1.Sniper 3 User Manual page 29

6) SATA3 0/1 (SATA 6Gb/s Connectors, Controlled by Intel Z77 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The "SATA3 0" and "SATA3 1"
connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connectors
with the "SATA2 2/3/4/5" and mSATA connectors.
for instructions on configuring a RAID array.
7) SATA2 2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel Z77 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
UG
Each SATA connector supports a single SATA device. The Intel Z77 Chipset supports RAID 0, RAID 1,
T
RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring
a RAID array.
DEBUG
PORT
(Note)
A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
•
are to be used, the total number of hard drives must be an even number.
A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does
•
not have to be an even number.)
A RAID 10 configuration requires four hard drives.
•
When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance
of the RAID set may vary depending on the devices being connected.
Refer to Chapter 5, "Configuring SATA Hard Drive(s),"
(Note)
SATA3
1
7
1
0
1
7
SATA2
1
7
1
7
- 29 -
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Pin No. Definition
1 GND
2 TXP
5 3
3 TXN
4 2
4 GND
5 RXN
6 RXP
7 GND
Hardware Installation