Table of Contents
Advertisement
Main
Advanced
Supervisor Password : Installed
User Password
Change Supervisor Password
Change User Password
Password Check
Password Lock Mode
Removable Device Boot
Flash Write
Change User Password
Select this item to set or change the user password. The User Password item on
top of the screen shows the default Not Installed. After you set a password, this
item shows Installed.
To set a User Password:
1.
Select the Change User Password item and press <Enter>.
2.
On the password box that appears, type a password composed of at least six
letters and/or numbers, then press <Enter>.
3.
Confirm the password when prompted.
The message "Password Installed" appears after you set your password
successfully.
To change the user password, follow the same steps as in setting a user password.
Password Check [Setup]
When set to [Setup], BIOS checks for user password when accessing the Setup
utility. When set to [Always], BIOS checks for user password both when accessing
Setup and booting the system. Configuration options: [Setup] [Always]
Password Lock Mode [Disabled]
When set to [Enabled], the keyboard will be locked during the adapter card
installation. Configuration options: [Disabled] [Enabled]
Removable Device Boot [Enabled]
When this item is set to [Disabled], the system cannot boot from the removable
devices. Configuration options: [Disabled] [Enabled]
Flash Write [Enabled]
When this item is set to [Disabled], the BIOS flash memory will be write-protected.
Configuration options: [Disabled] [Enabled]
5-32
BIOS SETUP UTILITY
Server
Security
: Not Installed
[Setup]
[Disabled]
[Enabled]
[Enabled]
Boot
Exit
Install, change or
clear the password.
Chapter 5: BIOS setup
Advertisement
Table of Contents
