Installing The Motherboard; Installing An Expansion Card - Gigabyte GA-B75-DS3V Manual

Step
4

Installing the Motherboard

Step
5

Installing an Expansion Card

PCI Express Graphics Card
Step
6
Installing IDE and SATA Devices
6-1 Install your optical drives, such as DVD-ROM and CD-ROM drives.
Remove the 5.25" drive bay cover from the front of the case. Mount the optical drive
in the 5.25" drive bay and secure it with screws.
Installing an Optical Drive
6-2 Install your IDE and SATA hard drives.
Install the hard drive into a drive bay within the case and secure it with screws.
Installing a Hard Drive
• One motherboard IDE connector can connect up to two IDE devices. Prior to installation, check the jumper
settings (master and slave) on your IDE devices.
• If more than one hard drive is installed, enter system BIOS Setup to set the hard drive boot sequence.
Remove the original I/O shield from the back of the case and replace it with the
motherboard I/O shield. Place the motherboard within the case by positioning it
into its I/O shield. Align the mounting screw holes on the motherboard with their
corresponding mounting holes on the case. Secure the motherboard in place
with screws.
I/O Shield
Locate an expansion slot that supports your card and remove the slot cover from
the case back panel. Then insert the expansion card into the slot. Secure the
expansion card's bracket to the case back panel with a screw.
• Before purchasing an expansion card, check the length of the card, making
sure it can fit into your case.
• Make sure that the expansion card is fully seated in its slot.
- 3 -