Samsung HG40NB678FF Installation Manual page 27

Setting Auto Initialize
¦
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings: Picture,
Sound, Input, Channel, Setup, and Hotel Setup. This lets you set nearly all the menu values on your hospitality TVs to the
same, standard settings. If you allow guests access to the guest side menus, for example - the Picture menu - they can
change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize function to On, the
TV automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV is turned off
and then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only. Settings which
have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function to
On.
Menu
Picture Mode
Backlight
Contrast
Brightness
Sharpness
Color
Tint (G/R)
Picture Size
Picture Size
Position
PIP
Advanced Settings
Dynamic Contrast
Black Tone
Picture Menu
Flesh Tone
RGB Only Mode
Color Space
White Balance
Gamma
Motion Lighting
Picture Option
Color Tone
Digital Clean View
MPEG Noise Filter
HDMI Black Level
Film Mode
LED Clear Motion
Picture Off
Reset Picture
Menu Item Menu
Sound Mode
Sound Effect
DTS TruSurround
DTS TruDialog
Equalizer
Speaker Settings
Sound Menu
Speaker Select
Auto Volume
Digital Audio Out
Audio Format
Audio Delay
Reset Sound
Setup
Menu Language
Time
Clock
Sleep Timer
On Timer
Off Timer
Eco Solution
Energy Saving
Eco Sensor
System Menu
No Signal Power Off
Auto Power Off
Auto Protection Time
Change PIN
General
Game Mode
Boot Logo
Anynet+ (HDMI-CEC) : Depend on the model.
Anynet+ (HDMI-CEC)
Auto Turn Off
DivX® Video On Demand
Menu Item
English
27