Samsung HG40NB678FF Installation Manual page 26

Multi Code Remocon
¦
A Multi Code Remocon is a special remote which is designed to control multiple TVs.
This function is useful where there is more than one TV in a location.
You can control up to 10 TVs with a different ID code of each remote with no conflicts between the TVs. ID numbers are
displayed on each TV's OSD.
The Initial ID code for each TV is "0".
– You can set and reset the ID code in Analog TV mode or PC mode. (Not available in DTV mode.)
– You can set the ID code to any digit from 0 to 9.
– To set a TV's ID code, follow these steps:
1. Aim the remote at the TV, and then press the
7 seconds. When you stop pressing the buttons, the TV displays the current ID in the middle of the screen and the
words, "Remote control code is set to x. If you want to change the Remote control code, enter the digit you want to
change."
2. Press the number on the remote you want to assign to the TV. The TV displays the following words:
"Remote control code is changed to x."
✎
The TV will display the OSD until you press the Exit button.
See the example below.
Remote control code is set to 0. If you want to change
Remote control code, enter the digit you want to
change.
Example: After you see the message above, if you press 1, the TV and Remote will be set to ID code 1. The TV then
displays the following message: "Remote control code is changed to 1"
The TV can then only be controlled by a remote which has the same ID code (1).
– To reset the ID code, press the
you stop pressing the buttons, the ID codes of the TV and Remote are reset to "0". "Remote control code is set to 0."
appears on the TV.
26
English
MUTE button and the
MUTE button and the EXIT
RETURN button simultaneously for more than
button simultaneously for more than 7 seconds. When