Asus H87M-PLUS User Manual page 66

MISC
MRC Fast Boot [Auto]
Allows you to enable, disable or automatically set the MRC fast boot. Configuration
options: [Auto] [Enable] [Disable]
DRAM CLK Period [Auto]
Configuration options: [Auto] [1] – [14]
Channel A DIMM Control [Enable Bot...]
Configuration options: [Enable Both DIMMS] [Disable DIMM0] [Disable DIMM1]
[Disable Both DIMMS]
Channel B DIMM Control [Enable Bot...]
Configuration options: [Enable Both DIMMS] [Disable DIMM0] [Disable DIMM1]
[Disable Both DIMMS]
Scrambler Setting [Optimized ...]
Allows you to set the optimized setting for stability. Configuration options: [Optimized
(ASUS] [Default (MRC)]
DIGI+ VRM
CPU Load-Line Calibration [Auto]
Load-line is defined by Intel VRM specification and affects CPU voltage. The CPU
working voltage will decrease proportionally to CPU loading. Higher value gets a
higher voltage and better overclocking performance, but increases the CPU and VRM
thermal conditions. This item allows you to adjust the voltage range from the following
percentages to boost the system performance: 0% (Regular), 25% (Medium), 50%
(High), 75% (Ultra High), and 100% (Extreme). Configuration options: [Auto] [Regular]
[Medium] [High] [Ultra High] [Extreme]
The actual performance boost may vary depending on your CPU specification.
CPU Fixed Frequency [XXX]
This item allows you to set a fixed CPU frequency. Use the <+> or <-> keys to adjust
the value. The values range from 200kHz to 350kHz with a 50kHz interval.
CPU Power Phase Control [Auto]
Allows you to set the power phase based on the CPU. Configuration options: [Auto]
[Standard] [Optimized] [Extreme] [Manual Adjustment]
DO NOT remove the thermal module when setting this item to [Extreme] and [Manual
Adjustment]. The thermal conditions should be monitored.
This following item appears only when you set the CPU Power Phase Control item to
[Manual Adjustment].
3-14
Manual Adjustment [Fast]
Allows you to set a response for the CPU power phase control.
Configuration options: [Ultra Fast] [Fast] [Medium] [Regular]
Chapter 3: BIOS setup