Oven Installation; Mounting Plate; Mounting Oven To The Wall - Viking RVMHC330 Installation Manual

Oven Installation

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT
REFERRING TO THE MOUNTING INSTRUCTIONS
FOUND ON WALL AND TOP CABINET TEMPLATES.

Mounting Plate

• Separate 4 Toggle Bolts, packed in the INSTALLATION
HARDWARE, from the Toggle Nuts.
Toggle Bolt
Mounting Plate
MOUNTING PLATE: Use wood screws to attach mounting
plate to the stud or studs. Use Toggle Bolts to attach
mounting plate through the holes at A, B, C and D UNLESS
THOSE HOLES ARE LOCATED ON THE STUD. Insert one
Toggle Bolt into A, B, C and D where appropriate (these
correspond to holes of the Wall Template) and put the
Toggle Nuts onto the Toggle Bolts.
• Refer to instructions in Wall Template.
MOUNTING PLATE: Position the Mounting Plate with
the Toggle Bolts attached at the wall location and insert
Toggle Nuts and Bolts through the holes in the wall with
the Toggle Nuts closed. Use Wood Screws to attach the
Mounting Plate to studs.
Toggle Nut
(A)
Space more
than wall
thickness
(B)
Wall
(A)
notE:
Before insertion, be sure you leave a space more than
the thickness of the wall between the Mounting Plate
and the end of each of the Toggle Nuts (in the closed
position). If you do not leave enough space, the Toggle
Nut will not be able to open on the other side of the wall.
Also, once a Toggle Nut opens, it cannot be withdrawn
from the hole; therefore make sure all of the Toggles are
in the correct position before insertion.
MOUNTING PLATE: Align the Mounting Plate carefully
and hold in position while tightening Toggle Bolts. Pull
Toggle Bolt toward you and turn clockwise to tighten.

Mounting Oven to the Wall

Utilization of the carton may make installation easier.
Top Side
MOUNTING OVEN TO THE WALL: Place carton upside
down.
E6
(B)
Cutting Line