Whirlpool WGD4910XQ Instructions Manual page 15

5.
Remove screws from door
Remove screws at top, bottom, and side of door (4 screws)
that hold the inner and outer door together. Holding door over
towel on dryer, grasp sides of outer door and lift to separate it
from inner door. Set outer door aside.
NOTE: Do not pry apart with putty knife or screwdriver.
Do not pull on door seal or plastic door catches.
6.
Switch door catch, bezel, & plug
Catch and bezel
Remove the door catch, bezel, and plug from the inside of
the inner door by squeezing and pulling/pushing them. Place
the door catch, bezel, and plug on the sides opposite from
where they were.
7.
Rotate outer door
Rotate outer door 180º and set it back down on inner door.
Reattach outer door panel to inner door panel so handle is
on the side where hinges were just removed. Insert 4 door
screws.
8.
Flip door over so handle side is down.
9.
Plug
Reattach door hinges to dryer door so that the larger hole is
at the bottom of the hinge.
Flip door over
Attach door hinges
15