Dell XPS /Dimension Gen 4 Service Manual page 19

1. Follow the procedures in "Before You
2. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (CLR CMOS) on the
b. Remove the jumper plug from pins 2 and 3.
c. Place the jumper plug on pins 1 and 2 and wait approximately 5 seconds.
d. Replace the jumper plug on pins 2 and 3.
3. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
4. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
Begin."
system board.