Table of Contents
Advertisement
Restoring factory settings in Setup Utility (BIOS)
NOTE:
Restoring defaults will not change the hard drive mode.
To return all settings in Setup Utility (BIOS) to the values that were set at the factory, follow these
steps:
1.
Turn on or restart the computer, and then press
Menu" message is displayed at the bottom of the screen.
2.
Press
3.
Use the arrow keys to select Exit > Load Setup Defaults. Press enter.
4.
Follow the on-screen instructions.
5.
To save your changes and exit, press f10, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Exit > Exit Saving Changes, and then press enter.
Your changes go into effect when the computer restarts.
NOTE:
Your password settings and security settings are not changed when you restore the factory
settings.
Exiting Setup Utility (BIOS)
●
To exit Setup Utility (BIOS) and save your changes from the current session:
If the Setup Utility (BIOS) menus are not visible, press
use the arrow keys to select Exit > Exit Saving Changes, and then press enter.
●
To exit Setup Utility (BIOS) without saving your changes from the current session:
If the Setup Utility (BIOS) menus are not visible, press
use the arrow keys to select Exit > Exit Discarding Changes, and then press enter.
90
Chapter 13 Setup Utility (BIOS) and System Diagnostics
f10
to enter Setup Utility (BIOS).
esc
while the "Press the ESC key for Startup
esc
to return to the menu display. Then
esc
to return to the menu display. Then
Advertisement
Table of Contents
