Set-Up; Power Save - FujiFilm FinePix A203 Owner's Manual

g POWER SAVE
SET–UP
ＳＥＴ−ＵＰ ＳＥＴ−ＵＰ
ＰＯＳＴＶＩＥＷ ＰＯＳＴＶＩＥＷ ＯＮ
ＰＯＷＥＲ ＳＡＶＥ
ＵＳＢ ＭＯＤＥ
ＤＡＴＥ／ＴＩＭＥ ＤＡＴＥ／ＴＩＭＥ
hPower saving "ON" (default setting)
Power consumption is kept to a minimum to
prevent battery depletion. You should select the
"ON" setting when you are using alkaline
batteries.
iIf the camera is not used for approximately 30
seconds, the LCD monitor switches off temporarily
to reduce power consumption (Sleep mode).
iOnce the camera is in Sleep mode, if it is left
unused for a further 90 seconds, it is automatically
switched off.
iThe charging time for the flash increases slightly
because the flash charging power is reduced.
hPower saving "OFF"
Batteries are more likely to run flat since no
power reduction measures (sleep mode, etc.)
are used. However, this function automatically
switches the camera off if the camera is not
74
used for approximately 2 minutes.
ＯＮ
ＯＮ ＯＮ
ＤＳＣ ＤＳＣ ＤＳＣ ＤＳＣ ＤＳＣ
ＳＥＴ ＳＥＴ
ＢＡＣＫ ＢＡＣＫ ＢＡＣＫ
When the camera is in Sleep mode, pressing
any button on the camera will switch the LCD
monitor back on. You can take a picture even
while the LCD monitor is switched off simply by
pressing the shutter button.
G
!
If you press the shutter button down halfway and
then release it, the screen may go dark briefly
because the flash is charging.
G
!
The Power Save and Auto Power Off functions are
disabled during USB connection.
The Sleep function does not operate when
the LCD monitor is switched off, during
setup, or in Playback mode, but the camera
still switches off automatically if it is not used
for 2 minutes.