Dell PowerConnect W-IAP175P Quick Setup Manual page 8

Dell Networking Mobility Starter Kit – Quick Setup Guide
To add a management station:
Please enter the SNMP community string to be used:
6. Enter the SNMP community string. You can use the default name "public"
Please enter the IP address of the Management System (A.B.C.D) or
wildcard (0.0.0.0) to manage from any Management Station: [0.0.0.0].
7. Enter the SNMP Management System IP.
8. Set up user account privilege level, as follows:
The following information is displayed:
Now we need to set up your initial privilege (Level 15) user account.
This account is used to login to the CLI and Web interface. You may set
up other accounts and change privilege levels later.
information on setting up user accounts and changing privilege levels,
see the user documentation.
To set up a user account:
Enter the user name:
Please enter the user password:
Please reenter the user password:
9. Enter the following:
•
User name, for example "admin"
•
Password and password confirmation.
10. Press Enter.
The following information is displayed:
Next, an IP address is setup. The IP address is defined on the default
VLAN (VLAN #1). This is the IP address you use to access the Telnet,
Web interface, or SNMP interface for the switch.
To set up an IP address:
Please enter the IP address of the device (A.B.C.D):
Please enter the IP subnet mask (A.B.C.D or nn):
11. Enter the management IP address and IP subnet mask, for example 192.168.2.100 as the IP
address, and 255.255.255.0 as the IP subnet mask.
12. Press Enter.
The following information is displayed:
Finally, set up the default gateway.
Please enter the IP address of the gateway from which this network is
reachable (e.g. 192.168.2.1). Default gateway (A.B.C.D):[0.0.0.0]
For more
8