Assignment Of Digital Audio In- And Outputs; Digital Audio Output - Sharp Aquos LC-26GD7E Operation Manual

Operating additional equipment

Assignment of digital audio in- and outputs

Audio input "AUDIO DIGITAL IN"
The TV set has a coaxial digital audio input "AUDIO DIGITAL IN" and a
coaxial digital audio output "AUDIO DIGITAL OUT". If you are using an
external digital surround amplifi er for sound reproduction, you have to
feed digital audio signals to the TV, e.g. from the DVD player.
EXT2
DVD
MULTICHANNEL AUDIO OUT
LEFT CENTER LEFT
REAR
FRONT
DIGITAL AUDIO OUT
STEREO OUT VIDEO OUT
PCM/MPEG2/AC3/DTS
MAINS
RIGHT SUBW. RIGHT R L (CVBS) (Y/C)
OPT OUT DIG OUT REAR FRONT AUDIO VIDEO OUT S-VIDEO OUT
Connect the output socket of the DVD player ("DIG OUT") to the TV's
"AUDIO DIGITAL IN" socket with a cinch cable.
In the connection wizard you specify that audio transmission is to be
digital. Specify that the digital sound is to be assigned for example to the
Euro AV socket 2 to pass on the digital sound to the digital audio output
of the TV set and via this to the external audio amplifi er. Further informa-
tion about this can be found on page 33.
32
AUDIO DIGITAL
IN OUT
Surround Amplifier
I
PREOUT
AUX- I /O AUX1 IN AUX OUT AUX 2
FL C FR
L L
DIGITAL
IN
II
DIGITAL
TO TV- I /O
OUT
SL SUB SR R R

Digital audio output

The digital audio signal is applied at the "AUDIO DIGITAL OUT" socket of
the TV. For example, you can connect an external digital audio amplifi er
here.
An analogue audio signal from the TV set or another sound source which
is received at one of the Euro-AV sockets of the TV set is converted into
a digital signal (PCM) and output at the "AUDIO DIGITAL OUT" socket.
Conversion from external analogue AV sources to PCM is not possible
if the loudspeaker of the TV set is used as a centre channel. In this case
connect your audio amplifi er additionally to the TV ("AUDIO OUT L/R")
with a cinch cable and switch the audio amplifi er to analogue audio input.
The digital TV sound or the digital sound of a connected auxiliary device
is only audible via an external digital audio amplifi er.
Sound selection
If you are receiving a digital TV programme with several sound formats,
you can call up the menu "Language/sound selection" by pressing the
END button. Press the green button after this.
If you have connected an external Dolby Digital decoder and have entered
this in the connection wizard, you should now select "Dolby Digital".
Note: The sound outputs of the TV set and speakers do not emit any
sound signals in this operating mode (Exception: the TV speakers are
used as active centre channel).
Only Stereo/PCM is reproduced with the setting "Sound via TV". This
must be considered when selecting the sound.