Washing Procedure; To Wash - Samsung SWT13H2 Owner's Instructions Manual

TO WASH

1. Before starting washing, check the
following; Connect the water supply
hose and open the water tap.
• Lay the drain hose down toward a
sinkhole. (In case no drain pump)
• Place the drain hose in sink or bath.
(In case no drain pump)
• Connect the power cord to the power
supply outlet.
2. Set the CYCLE
SELECTOR KNOB to
the desired mode.
3. Set the WASH
SELECTOR KNOB to
'NORMAL or HEAVY'.
(In case drain pump
"WASH") .
4. Set the WATER
SELECTOR
KNOB to WASH.
5. Load laundry in the
wash tub.
6. Fill water in the
wash tub and
add the detergent.

WASHING PROCEDURE

7. Set the WASH TIMER 1-35 minutes.
SOAK
SOAK
• Set the WASH TIMER
to the point more
than "15" for SOAK
function.
• If the WASH TIMER is
set to the point less
than "15", it leads to
WASH only. (No SOAK)
• If Although the machine may stay still
maximum 5 minutes, if the WASH
TIMER is indicated over 15 minutes
position, it is just in the process
of soaking and not a breakdown.
8. After washing, set the
CYCLE SELECTOR
KNOB to 'DRAIN'
for drain.
9. Soak-Washing
1) Place clothes into the WASH TUB.
2) Turn on tap or use bucket to fill the
WASH TUB with desired amount of
water.
3) Put detergent depending on the
water volume and detergent
package indications.
4) Set WASH TIMER to point between
"15" to "35" in the timer.
• Soak-Washing automatically
starts the wash (15 min.) after the
soak (2 to 20 min.) is completed.
• The SOAK function (20 min.)
repeats the cycle that is
1.5 ~ 2.0 min. turning and
the next 5 min. resting 3 times.
4