Checking The Signal Information; Upgrading The Software - Samsung LE40F8 Owner's Instructions Manual

Checking the Signal Information

You can get information about the signal status.
1. Press the menu button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press
the enter/oK button.
2. Press the ▲ or ▼
enter/oK button.
. Press the ▲ or ▼ button to select "System", then press the
enter/oK button.
. Press the ▲ or ▼ button to select "Signal Information",
then press the enter/oK button.
. Press the exIt button to exit.
If the signal status is poor, the "No signal." message is
displayed.

upgrading the Software

to keep your product up-to-date with new Digital television
features then software upgrades are periodically broadcast
as part of the normal television signal.
It will automatically detect these signals and display the
software upgrade banner. You are given the option to install
the upgrade.
1. Press the menu button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press
the enter/oK button.
2. Press the ▲ or ▼
enter/oK button.
. Press the ▲ or ▼ button to select "System", then press the
enter/oK button.
. Press the ▲ or ▼ button to select "Software Upgrade",
then press the enter/oK button.
. Press the ▲ or ▼ button to select "Software Infomation",
"Manual Upgrade" or "Satandby Mode upgrade".
Press the enter/oK button.
♦ Software Inforamtion
Press the enter/oK button, then the current software version is shown. To display the software
version information, press the enter/oK button again.
To switch to an alternative version, press the red button.
Press the blue button to reset, activate the upgrade and restart.
♦ Manual Upgrade
Press the enter/oK button to search for new software from the currently broadcasting channels.
♦ Standby Mode Upgrade : On / Off
Press the enter/oK button. To continue software upgrade with master power on, Select On
by pressing the ▲ or ▼ button. 45 minutes after entering standby mode, a manual upgrade is
automatically conducted. Since the power of the unit is turned on internally, the screen may be on
slightly for the LCD product. This phenomenon may continue for more than 1 hour until the software
upgrade is completed.
. Press the exIt button to exit.
button to select "Setup", then press the
button to select "Setup", then press the
english - 
Signal Information
Service: ?
Service ID:0000
multiplex: ? (tSID 0000, onID 0000)
network: ? (ID 0000)
bit error level: 10
Signal Strength: 0
move enter return
return
System
Product Information
Signal Information
Software upgrade
Common Interface
reset
move enter return
Software upgrade
Software Information
manual upgrade
Standby mode upgrade : on
move enter return






