Specifications; Maintenance Of External Surfaces - Pioneer A-509R Operating Instructions Manual

SPECIFICATIONS

Amplifier Section
Continuous power output
(both channels driven at 20 Hz to 20 kHz)**
T.H.D. 0.06 %, 8 ............................................ 45 W + 45 W*
T.H.D. 0.09 %, 4 ............................................ 65 W + 65 W*
DIN Continuous power output (both channels driven at 1 kHz)
T.H.D. 1.0 %, 8 ................................................ 60 W + 60 W
T.H.D. 1.0 %, 4 ................................................ 90 W + 90 W
Total harmonic distortion**
20 Hz to 20 kHz, 20 W, 8
÷ Power output specification is for when power supply is 230V.
Input sensitivity/ impedance
PHONO (MM) ................................................... 2.8 mV/ 50 k
CD, TUNER, LINE/SB, TAPE 1/CD-R/MD,
TAPE 2 MONITOR ........................................... 200 mV/ 50 k
PHONO (MM) overload level
1 kHz, T.H.D. 0.1 % ...................................................... 150 mV
Output level/ impedance
TAPE 1/CD-R/MD, TAPE 2 MONITOR output
............................................................................ 200 mV/ 1 k
Frequency response
PHONO (MM) ................................. 20 Hz to 20 kHz
CD, TUNER, LINE/SB, TAPE 1/CD-R/MD,
TAPE 2 MONITOR .............................. 5 Hz to 100 kHz
Tone control
BASS ..............................................................
TREBLE ...........................................................
Loudness contour (volume control set at – 30 dB position)
.............................................. + 5 dB (100 Hz)/ + 3 dB (10 kHz)

MAINTENANCE OF EXTERNAL SURFACES

• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the surfaces are very dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six times with
water, and wrung out well, and then wipe again with a dry
cloth. Do not use furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays and other
chemicals on or near this unit, since these will corrode the
surfaces.
PIONEER CORPORATION
PIONEER ELECTRONICS [USA] INC.
PIONEER ELECTRONICS OF CANADA, INC.
PIONEER ELECTRONIC [EUROPE] N.V.
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
PIONEER ELECTRONICS DE MEXICO S.A. DE C.V.
12
<00B00ZF0C00>
<ARB7238>
......................................... 0.05 %*
0.5 dB
+0
- 3
8 dB (100 Hz)
8 dB (10 kHz)
4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
P.O. BOX 1540, Long Beach, California 90801-1540, U.S.A.
300 Allstate Parkway Markham, Ontario L3R OP2, Canada
Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium TEL: 03/570.05.11
178-184 Boundary Road, Braeside, Victoria 3195, Australia TEL: [03] 9586-6300
San Lorenzo Num 1009 3er piso Desp. 302 Col. Del Valle, Mexico D.F. C.P. 03100 TEL: 5-688-52-90
Signal-to-Noise ratio (IHF short circuit, A network)
PHONO (MM, 5 mV input) ........................................... 86 dB*
CD, TUNER, LINE/SB, TAPE 1/CD-R/MD,
TAPE 2 MONITOR ...................................................... 106 dB*
Signal-to-Noise ratio (DIN, continuous power/ 50 mW)
PHONO (MM) ................................................... 71 dB/ 67 dB*
CD, TUNER, LINE/SB, TAPE 1/CD-R/MD,
TAPE 2 MONITOR ............................................ 95 dB/ 71 dB*
Power Supply/ Miscellaneous
Power requirements ............................ AC 220 - 230 V, 50/ 60 Hz
Power consumption ............................................................ 160 W
Power consumption in standby mode .................................. 1 W
AC outlet
Switched (x1) ..................................................................... 100W
Dimensions (including knobs and other protruding parts)
............................................. 420 (W) X 335 (D) X 128 (H) mm
Weight (without package)
......................................................................................... 6.9 kg
Accessories
Remote control unit ..................................................................... 1
Batteries (AA/R6P) ........................................................................ 2
Operating instructions ................................................................. 1
dB*
Power cord(Rated current 2.5 A) ................................................. 1
Warranty card ............................................................................... 1
NOTE:
Specifications and design subject to possible modification with-
out notice, due to improvements.
* Measured with the DIRECT/SB MODE button set to on.
(at DIRECT ON mode, SB OFF mode)
** Measured by Audio Spectrum Analyzer.
Published by Pioneer Corporation.
Copyright © 2000 Pioneer Corporation.
All rights reserved.
Printed in Japan <ARB7238-A>