Table of Contents
Advertisement
Disassembly and Assembly instructions
1) Screw up the FOLDER UPPER at the above
5
two points.(M1.4xL4)
1) Be careful not to make scratch and molding damage!
2) Use 1.2 ± 0.2 Kgf.cm!
1) Insert LCD FPCB[which is connected to
7
FOLDER] into the bottom of FRONT Hinge.
2) The FOLDER's projection inserts the
FRONT'S hole when Projection is pushed
3) Assemble FOLDER with FRONT
1) Be careful not to make scratch and molding damage!
This Document can not be used without Samsung's authorization
SAMSUNG Proprietary-Contents may change without notice
1) Attach Screw rubber caps on the screws
6
by using a pincette.
1) Be careful not to make scratch and molding damage!
1) Attach FRONT Protection TAPE as a above
8
picture is shown.
Attach FRONT
Protection TAPE!
1) Be careful not to make scratch and molding damage!
8-4
Advertisement
Table of Contents
