Table of Contents
Advertisement
2 . C i r c u i t
D e s c r i p t i o n
2-1. SGH-E730 RF Circuit Description
2-1-1. RX PART
- ANTENNA SWITCH (Module1 Front End Module)
¡æ Switching Tx, Rx path for GSM900, DCS1800 and PCS1900 by logic controlling.
- ANTENNA SWITCH Control Losic (Module1) ¡æ Truth Table
Tx Mode (GSM900)
Tx Mode (DCS1800/1900)
Rx Mode (GSM900)
Rx Mode (DCS1800)
Rx Mode (PCS1900)
- VC-TCXO (U102)
This module generates the 26MHz reference clock to drive the logic and RF.
It is turned on when the supply voltage Vcc(SYN) is applied.
After buffering a reference clock of 26MHz is supplied to the other parts of the system
through the transceiver pin CLKOUT.
- TRANSCEIVER (U100)
This chip is fully integrated GSM GPRS quad-band transceiver with transmit baluns(balanced-unbalanced matching devices)
, loop filters and most of the passive component in it.
And also fully integrated fractional N RF synthesizer with AFC control possibility, RF VCO with integrated supply
regulator. Semi integrated reference oscillator with integrated supply regulator.
RF Receiver front-end amplifies the E-GSM900, DCS1800 and PCS1900 aerial signal, convert the chosen channel
down to a low IF of 100kHz.
In IF section, further amplifies the wanted channel output level to the desired value and rejects DC.
2-1-2. TX PART
The transmitter is fully differential using a direct up conversion architecture. It consists of a signal side band
power up mixer. Gain is controlled by 6 dB via 3-wire serial bus programing. The fully integrated VCO and power
mixer achieve LO suppression, quadrature phase error, quadrature amplitude balance and low noise floor specification.
Output matching/balun components drive a standard 50 ohms single ended load.
VC1
H
L
L
L
L
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
VC2
L
H
L
L
L
2- 1
VC3
L
L(H)
L
L
H
Advertisement
Table of Contents
