Table of Contents
Advertisement
13
Assembling MAIN KEY PAD
※ Be careful that you don't bend the KEY PAD
while putting the KEY PAD.
15
C h e c k l o c k i n g
p a r t
Put the PBA and MOTOR to the case.
1. Put PBA to FRONT ASS'Y(Check the locking part)
2. Put the motor to FRONT ASS'Y after turn it
half round clockwise.
X
Take note of being
bent of the KEY PAD
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Disassembly and Assembly Instructions
14
Soldering SLIDE F-PCB and attaching the
insulating TAPE
1. Insert the SLIDE F-PCB and then close the
locker.
2. Solder two wings on the Slide FPCB.
3. Attach the insulating tape on it.
16
②
Assembling REAR screwing up
1. Screw up 5 point after putting the rear case.
※ The EARPHONE COVER is seceded easily.
11-9
①
③
Advertisement
Table of Contents
