Table of Contents
Advertisement
Available languages
Available languages
5.7 cu ft DRYER (STYLE 3) INSTRUCTIONS (WHITE KIT)
C
) Attaching dryer (style 3) mounting
5
hardware
1.
Use the following instructions for mounting this type of dryer to
the pedestal:
Dryer cabinet (style 3)
with 2 indents on side
and 4 inch knockout for
side venting.
2.
Remove all 4 adjustable leveling legs from the appliance base
and save for future use.
3.
Remove 2 plastic hole plugs toward bottom of front panel.
4.
Attach each front clip to outer-most set of holes with 2 screws.
5.
Insert "B" tab of each rear bracket into the front slots on rear of
pedestal. Orient bracket outward for "style 3" dryer mounting.
"B"
tab
front
slot
6.
Install 2 screws through each rear bracket into aligning pedestal
holes.
Dryer console (style 3) has
mechanical style timer.
Remove 2 plastic hole
plugs toward bottom
of front panel.
Remove 4 plastic leveling legs.
outward
D
) Mounting dryer (style 3)
5
- EXCESSIVE WEIGHT HAZARD -
back or other injury, have more than one person move or lift
the dryer.
1.
Using two or more persons, slightly tip the dryer back and lift it
onto the pedestal. Still tipped, slide the dryer back against the
rear brackets so tabs on rear brackets engage the slots on the
back of the dryer. Gently set down the front so the appliance is
between the front and rear brackets.
SLIDE BACK
TIP DOWN
2.
Adjust the appliance side-to-side to align its mounting holes with
the pedestal's bracket holes.
3.
Install a screw through the inner hole of each front bracket into
the base of the dryer.
4.
Reinstall the plastic hole plugs in front panel.
E
) Installing or re-installing dryer (style 3)
5
1.
Slide appliance/pedestal into place.
2.
Check for levelness and rock all four (4) legs again. Repeat until
level and solid.
3.
Refer to
Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
7
To avoid
ENGAGE REAR TABS
Advertisement
Table of Contents
