Table of Contents
Advertisement
Available languages
Available languages
3.5 cu ft WASHER INSTRUCTIONS (GREEN KIT)
C
) Attaching washer mounting hardware
1
1.
Use the following instructions for mounting either of these types
of washers to the pedestal:
2.
Attach each front clip to outer-most set of holes with 2 screws
and supplied spacer.
Locate spacer under each front bracket.
3.
Insert "A" tab of each rear bracket into the middle slots on rear
of pedestal. Orient bracket inward for washer mounting.
"A"
middle
tab
slot
4.
Install 2 screws through each rear bracket into aligning pedestal
holes.
D
) Mounting washer
1
back or other injury, have more than one person move or lift
the washer.
1.
Using two or more persons, slightly tip the washer back and lift it
onto the pedestal. Still tipped, slide the washer back against the
rear brackets and gently set down the front so the appliance is
between the front and rear brackets.
SLIDE BACK
2.
Adjust the appliance side-to-side to align its mounting holes with
the pedestal's bracket holes.
3.
Install 2 screws through each rear bracket into the base of the
washer.
4.
Install a screw through each front bracket into the base of the
washer.
inward
E
) Installing or re-installing washer
1
1.
Slide appliance/pedestal into place.
2.
Check for levelness and rock all four (4) legs again. Repeat until
level and solid.
3.
Refer to
Washer Installation Instructions for complete details
on installing water, drain, or electrical.
3
- EXCESSIVE WEIGHT HAZARD -
TIP DOWN
To avoid
Advertisement
Table of Contents
