Table of Contents
Advertisement
6-2. Assembly
1
Put the MOT/SPK/CON TO
CON and HOLE COVER
1. insert CON TO CON to LOWER CON HOLE
2. PUT the LCD / MOT / SPK / CON HOLE COVER
in order
※ caution
1. Handle wires and CON TO CON with care
2. Check every thing is proper place and
conformed
3. Do not touch front side of LCD (fingerprint)
3
1. Tighten LOWER SCREW (2 POINT)
2. Insert the SCREW CAPS
※ caution
This Document can not be used without Samsung's authorization
Check the wire
CON HOLE
COVER
SCREW CAP
LOWER
SCREW
SAMSUNG Proprietary-Contents may change without notice
Disassembly and Assembly instructions
2
FOLDER
UPPER
1.Assemble FOLDER UPPER, Follow the picture
1-2-3
※ caution
4
1. Put the LCD CON TO CON through the hole and
insert to HINGE HOUSING
2. After finishing left side, bend front cover to
make space and push the hinge in.
3. Repeat open and close to place the hinge and
connector
※ caution
1. Handle the CON TO CON with care.
2. Do not make scratch at the hinge insertion
3. Check the FOLDER tension is good enough.
6-3
①
②
③
Advertisement
Table of Contents
