Changing A Flat Tire - Acura 2007 RL Owner's Manual

WHEEL NUT WRENCH
Loosen each wheel nut 1/2 turn
6.
with the wheel nut wrench.
Place the jack under the jacking
7.
point nearest the tire you need to
change. It is pointed to by a
mark molded into the underside of
the body. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
resting in the jack notch.

Changing a Flat Tire

WHEEL NUT WRENCH
EXTENSION
Use the extension and the wheel
8.
nut wrench as shown to raise the
vehicle until the flat tire is off the
ground.
9. Remove the wheel nuts, then
remove the flat tire. Temporarily
place the flat tire on the ground
with the outside surface of the
wheel facing up. You could scratch
the wheel if you put it face down.
CONTINUED
433