Acura 2007 RDX Manual page 106

llumination control
(Display mode)
button (See page 11)
Sunlight Sensor (Middle of
dash near the windshield).
(See owner's manual for
location)
Dash illumination adjustment
knob (See owner's manual for
location)
Headlights (On/Off)
Map Day/Night screen color
choice (see page 103 for the
Day and Night color choices)
Recommended Display mode Day/Night settings:
• With the headlights on, select mid range for the dash illumination (see owner's manual for location of knob).
• With the headlights off, select mid range for the dash illumination (see owner's manual for location of knob).
• On the Setup "Color" adjustment screen, choose White for the Day display, and black for the Night display (
Inappropriate adjustment of these colors can cause the Day/Night modes to appear inoperative.
• To allow the Sunlight sensor to function properly, avoid blocking the sensor with loose articles (see owner's manual for
location of sensor).
• Remember that once the
vehicle is restarted.
NOTE:
Loose articles in the center dash can block or interfere with the operation of the sunlight sensor. See the RDX owner's Manual for
additional information regarding the dash brightness adjustment.
Priority Operation
1 Allows selection of Day, Night or Off display
mode. This button has the highest priority and
overrides all other display control adjustments
listed below.
2 If the sunlight sensor detects daylight and the
headlights are turned on, the navi automatically
overrides (cancels) the Night display and
displays the Day display mode.
3 When headlights are turned on, and you wish to
have the Day display mode, then adjust the knob
clockwise to the full bright position (beeps).
4 When turned on, it changes the display to the
Night display mode. The previous 3 controls
listed above can "cancel" this function.
N/A The user can select the color of the screen that
will be displayed for the Day, and Night
display modes described above.
(Display mode) button is selected, the other display mode controls are overridden until the
System Set-up
Override conditions
When the car is restarted, the display mode
previously selected by this button is canceled,
and the display mode is determined by one of
the controls below.
If desired, use the (Display mode)
button to override this automatic choice.
When the headlights are turned ON, adjust the
dash brightness down (counterclockwise) from
the maximum brightness position.
(Display mode) button, or
Use the
adjust the dash illumination to full bright to set
the display to your desired choice.
For best contrast, ensure that the Map "color"
is white for Day, and black for Night.
see page 103
Navigation System 105
).