Table of Contents
Advertisement
Clearance Heights
The cooker hood is designed to be fitted over a
cooking appliance at the clearance heights stated,
providing the maximum output of the appliance
beneath does not exceed the maximums quoted in
the Technical Specifications.
If the output of the appliance below the cooker
hood exceeds the maximum outputs quoted,
please refer to the cooker manufacturer's
installation instructions.
A minimum clearance height of 650mm (25˚") is
required when installed above a built-in electric
hob, or 700mm (27˚") when installed above a built-
in gas hob.
A minimum clearance height of 685mm (27") is
required when installing above a slot-in electric
cooker, or 787mm(30˚") when installed above a
slot-in cooker.
When installed between adjoining wall cabinets,
the wall cabinets must not overhang the hob and
the distance between the underside of the cabinet
and the worktop must be 450mmm (17 "), a gap of
50mm (2") must be maintained either side of the
hob.
This cooker hood must not be installed
above a cooking appliance with a high
level grill.
Fitting the Wall Brackets
1.
Draw a vertical line on the wall from the
centre of the cooking appliance up to the
ceiling, using a spirit level and marking
pen. This is to ensure the correct vertical
alignment of the appliance.
2.
Draw a horizontal line through the vertical
at 270mm. Mark the centre positions for
the lower bracket fixing screws (1) at
110mm either side of the vertical line.
Ensure that the distance between the
lowest point of the hood and the cooking
appliance beneath meet the clearance
requirements quoted above.
3.
Draw a horizontal line through the vertical
at 45mm from the ceiling or from the
maximum height of the chimney. Mark the
centre positions for the upper bracket
fixing screws (2) at 80mm either of the
vertical line.
12
Advertisement
Table of Contents
