Filters - LinPlug Albino 3 Manual

Filters

The Albino 3 contains four types of filter: "Silk," "Cream," "Scream," and
"Comb." The first three of these are multi-mode filters, each having a
different design. A lot of care and attention has been paid to the Albino 3's
filter design in order to make them especially "musical" and to ensure that
they use very little CPU resources.
The Albino 3 has 2 filter modules, each of which can be set to one of the
four filter types mentioned above. To turn a filter on or off, select the
"On/Off" button to the right of the filter type menu. An important point to
note is that when a filter is turned off no audio can pass through it. To
change the filter type click on the menu to the right of the Filter label.
Each filter has its own "Sat" (Saturation) control located on the left of the
filter section. The Sat control is used to overdrive the Albino's filters. In
terms of signal flow, the Sat control precedes the filter so that the
overdriven signal passes through the filter. Four types of saturation are
available.
Each filter's controls differ slightly. These controls are described in detail
below.
Rob Papen Albino 3.0 23