Oscillators - LinPlug Albino 3 Manual

Oscillators

The Albino 3 contains 4 oscillators grouped into 2 pairs ("Osc 1/Osc 2",
"Osc 3/Osc 4"). Each oscillator pair is identical to the other except that
Oscillator 1 contains an additional Oscillator type—Audio Input. To change
oscillator pairs click on the buttons to the left of the Oscillator section.
Each Oscillator can be switched on or off using the Power button beside its
name or using the additional Power button next to the Oscillator Selector.
The status of each Oscillator is shown by the state of the button.
The Albino 3 contains four types of Oscillator module: "Analog", "Digital",
"Noise" and "Audio Input". Don't be confused by the use of the terms
"digital" and "analog" here; all of the Albino 3's oscillators are digital
(obviously!). In this case, we've used the term "digital" to describe
oscillators that use additive waveforms, while "analog" oscillators use
waveforms that are created in real-time much as in true analog
synthesizers.
As mentioned above, the Albino 3 contains several types of oscillator
module. To change the oscillator type click on the menu to the right of the
"Osc" label. When you change oscillator type, the Albino's display changes
accordingly.
Each oscillator's controls differ. These controls are described in detail
below.
Rob Papen Albino 3.0 16