Set Boot Priority Order - Gigabyte M912 User Manual

Set Supervisor Password
With this setting, only authorized user can enter the system. Follow
the below to set:
Select menu Security.

Select "Set Supervisor Password" and then press "Enter".

Input the desired password twice.

When the box of Setup Notice shows password information,

press "Enter
Set User Password
22 22
It's always the same to set user passport as that of supervisor
password. But the former can only enter OS, not BIOS Setup.
Password on Boot
This setting is to select whether password of supervisor and/or user
is needed when booting.
Fixed disk boot sector
This setting is to select whether to have Write Protect on hard disk
boot section to anti virus or not.
•••••••••••••••••••••••
Notice: Do not lose the password of your system. In the
event of this, you should have to refer to GIGABYTE
service center.

3.4 Set Boot priority order

With this setting, you can set the order of booting the hardware of
Netbook.
To select the boot device, you can use the up or down arrow key,
then press <+> to move up the device in the list or press <-> to
move down the device in the list. To exit from this menu, press
<Esc>.