Gigabyte 6VTXE-A User Manual page 42

6VTXE(-A) Motherboard
S.M.A.R.T. for Hard Disks
Enable Enable S.M.A.R.T. Hard for Disks.
Disable Disable S.M.A.R.T. Hard for Disks. (Default Value)
Interrupt Mode
APIC Through IOAPIC generate more IRQ for system use.(Default value)
PIC Use AT standard IRQ controllers to generate IRQ.
When you already have IOAPIC enable system and want to upgrade the system please
note, since running an IOAPIC enabled OS (like Windows NT,Windows 2000, Windows XP...)
system with none IOAPIC HW support will cause the system to hang. Following are some
situations users might run into: 1.An IOAPIC enabled OS and change the BIOS setting from
IOAPIC to PIC, this will cause your system to hang.
Boot Up Num-Lock
On Keypad is number keys. (Default Value)
Off Keypad is arrow keys.
Floppy Drive Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360
type is 40 tracks while 720 , 1.2 and 1.44 are all 80 tracks.
Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks.
Note that BIOS can not tell from 720, 1.2 or 1.44 drive type as they are
all 80 tracks.
Disabled BIOS will not search for the type of floppy disk drive by track number.
Note that there will not be any warning message if the drive installed is
360. (Default Value)
Password Check
Setup Set Password Check to Setup. (Default Value)
Always Set Password Check to Always.
Processor Serial Number
Disabled Disabled CPU Serial Number. (Default Value)
Enabled Enabled CPU Serial Number.
35