Remote Control - Gold Vision GV-P42V User Manual

Remote Control

The number in ( ) indicates the page in which
*
the function of each button is explained in detail.
Input Select button
44
Used to select a desired input.
Every press of the button cycles
through the five different modes:
Video 1 --> Video 2 --> PC --> DVI -->
Component 1 --> Component 2
ZOOM button
38
Used to zoom the screen. To enlarge,
press the (+) button, and to return to the
previous condition, press the (-) button.
(ZOOM Mode: Zoom 0~20)
Menu Select button
32
Select Menu by pressing
(Down), (Left), (Right) buttons.
31 Screen Select button
Every press of the button cycles through the four
different modes: Normal --> Dynamic --> Cinema
Sound Mode button
41
Every press of the button cycles through
the five different modes: Normal --> Movie
--> Music --> News --> User.
Mute button
Mutes sound.
When Using Remote Control:
•
Be sure not to allow the Remote Control to drop or to become wet.
•
Keep it away from hot or moist locations.
INPUT
SELECT
DISPLAY
ZOOM-
MENU
VOL
(Up),
PICTURE
MODE FREEZE
SOUND MUTE
--> User.
MODE
Note
• Use two "AAA" batteries.
• Be sure to use replacement batteries of the
same type as the original ones.
• The life of a battery depends on how much
it has been used.
POWER
Power button
Pressing the Power button of the Monitor
allows the Display to be standby. (Red light
is shown in the Remote Control Sensor.)
At this time, if you press the Power button
of the Remote Control, the Display is
turned ON (Green light in the Sensor).
Display button
ZOOM+
Indicates the current state and resolution.
Menu button
Used to display a desired menu.
Volume button
VOL
Adjusts the volume.
Aspect Ratio
Adjusts the size of the screen
SCREEN
MODE
(Normal, 16:9, etc.)
40
Still
SLEEP
Used to view a still picture during
watching moving images. (Sound
can be heard.)
Sleep Timer
Each time you press this button, a different
input mode appears.
The sequence is as follows:
15 Min. --> 30 Min. --> 60 Min. --> 90 Min. --> 120 Min. --> OFF
After the time is selected, it automatically
becomes stand-by state.
Installing the Batteries in your Remote Control:
•
To remove the cover, slide it outwards while pressing it down.
•
Place two batteries in the remote control by properly orienting
them, then close the cover.
•
Batteries could explode if aligned incorrectly.
•
Align the batteries according to the (+) and (-) indication inside
the case.
46
42
32
34
51
13