Programming Your Tv's Channel Memory; Source Selection; Auto Programming Function - Daewoo DTQ 25G1TS Instruction Manual

Programming Your TV's Channel Memory

Your TV automatically memorizes the channels you can receive. Once channels are memorized, you
can scan through them using WCHV buttons on the remote control or on the TV.

Source Selection

1. Press power to turn on the TV.
2. Press menu button on the remote control or on the TV to display the main menu.
2
Setup
Video
Audio
Timer
Function
Move Select
L Prev WV CB
3. Press WCHV buttons on the remote control or on the TV to select 'Auto Program' and press
CVOLB buttons on the remote control or on the TV.
4. Press WCHV buttons on the remote control or on the TV to select 'Source' and press CVOLB
buttons on the remote control or on the TV. If you connected to antenna to your TV, select 'Air', if
you connected a cable system, select 'CABLE'.
3
Setup
Auto Program CB To Press
Edit Program
Favorite Ch
Language
Captions
Power Restore
Input
L Prev WV Select CB Adjust
4
Auto Prog.
Source Air
Auto Program
L Prev WV Select CB Adjust

Auto Programming Function

1. Select Auto Program following step 2 and 3 in "SOURCE selection" above.
2. Press CVOLB(button an the remote control or on the TV) to start auto programming process. The
TV will automatically cycle through all the TV or CABLE channels on the mode selected by the
Air/Cable mode, and store active channels in the channel memory
3. Press menu button on the remote control or on the TV repeatedly to exit on-screen menu when
channel programming is complete. This process takes a few minutes.
4. Even if you don't press any button, the on-screen menu disappear after a few second.
2
Auto Prog.
Source
CB To Program
Auto Program
L Prev WV Select CB Adjust
Chapter 3 : Operating Your TV
TAND-BY CH VOL MENU
TAND-BY CH MENU
VOL
AND-BY CH VOL MENU
AND-BY CH VOL MENU
16