Inserting Batteries into the Remote Control Unit and Mains connection
Batteries
1. Open remote control battery compartment (at the rear) and insert two 1.5V type AAA batteries.
Warning: be careful to respect battery polarities.
2. Insert the main plug into a 220~240V 50Hz AC power socket.
3. Connect aerial to aerial jack (C3).
SWITCHING ON
1. If the Indicator is not lit, then the TV set is powered off. You must
press the button on the TV set. The set will switch to stand-by mode
and then the Indicator will illuminate in Red.
2. Press the POWER
button, UP/DOWN [ / ] button or
NUMBER button on the remote controller or UP/DOWN button on
the TV set.
The TV set will be switched on and then the Indicator will change to
Green.
SWITCHING OFF
1. Press the POWER
button on the remote controller to return the
set to its stand-by mode.
The Indicator will illuminate in Red.
2. Press the ON/OFF button on the TV set to switch the TV set off
completely.
NOTE: If you don't use the set for extended periods of time, unplug
the AC cord from the Power outlet.
Installation
Switching ON and OFF
9
NORMAL
RECALL
–"·
ABC
DEF
GHI
JKL
MNO
PQRS
TUV
WXYZ
OK/SELECT
GUIDE