Onboard Headers And Connectors - ASROCK P65iCafe User Manual

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA_0: see p.11, No. 12)
(SATA_1: see p.11, No. 20)
(SATA_2: see p.11, No. 13)
(SATA_3: see p.11, No. 18)
Serial ATA3 Connectors
(SATA3_1: see p.11, No. 14)
(SATA3_2: see p.11, No. 15)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.11 No. 22)
(9-pin USB8_9)
(see p.11 No. 21)
Infrared Module Header
(5-pin IR1)
(see p.11 No. 23)
SATA_0
SATA_2
SATA_1
SATA_3
SATA3_1
SATA3_2
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
IRTX
+5VSB
DUMMY
1
GND
IRRX
21
These four Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
These two Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
This header supports an
optional wireless transmitting
and receiving infrared module.