Table of Contents
Advertisement
(vi) The activity state of the pair of the specified MV and the paired upper MV is not in the Restore
(vii) The activity state of the pair of the specified RV and the paired lower RV is not in the Restore
(viii) The disk array where the specified MV and RV are stored is not Freeze state.
(ix) The disk array where the specified MV and RV are stored is monitored.
(x)
(xi) The specified MV is not registered in the AT-group.
(xii) Separate is not being performed between the upper volume and the lower volume that are paired.
(xiii) Snapshot is not in operation.
Figure 3-15 illustrates the execution conditions of Replicate. (Each of (i) to (xiii) in the figure
corresponds to the respective number above.)
(vi)
Not in the Restore state
(xii) Separate is not being
performed between the
upper volume and the
lower volume that are
paired.
MV
(v) Not in the Restore state
(xiii) Snapshot is not in operation.
state.
state.
The RV has been unmounted from the host.
Target Pair
RV
MV
Target Pair
MV
Target Pair
MV
BV
Figure 3-15 Execution Conditions of Replicate
Chapter 3 Replication Management
RV
RV
MV
(vii) Not in the Restore state
(xii) Separate is not being
RV
RV
RV
SV
53
(i)
Replication Target Disk
(ii)
Pair Setting
(iii)
Separated
(iv)
Semi-synchronous not
allowed for the same disk
array
(viii) Not in the Freeze state
(ix)
Disk array monitored
(x)
RV is unmounted from the
host.
(xi)
The specified MV is not
registered in the AT-group.
performed between the
upper volume and the lower
volume that are paired.
Advertisement
Table of Contents
