Optimus STAV-3590 Owner's Manual page 26

26
Follow these steps to train the STAV-3590 remote control.
1. Place both controls 1–2 inches apart with the windows facing each other,
as shown.
2. Press on the STAV-3590's remote control. The
LEARN
indicator flashes.
3. Select the
AUDIO VCR/TV
that best matches the function —to
to for a VCR or television.
VCR/TV
4. Within 1 minute, press the STAV-3590's remote button you want to train
with a pointed object, such as the tip of a pen. The
cator lights steadily.
5. Within 1 minute, press and hold the other device's remote control button
you want the STAV-3590 to learn. The
flashes.
If
TRANSMIT/LEARN
the remote controls closer together and try again.
If
TRANSMIT/LEARN
learning mode, the remote control's memory is full. Programming errors
can fill memory. For example, fluorescent light, direct sunlight, the two
remote controls being too far apart, or a low battery might cause this
error. Repeat the procedure.
6. Repeat Steps 4 and 5 to teach additional commands.
7. To exit the teaching mode, press
Using the Remote Control
switch position. Set the switch to the position
for a CD player or tape deck or
AUDIO
TRANSMIT/ LEARN
flashes twice, the signal might be too weak. Place
flashes four times and the remote control exits the
or wait 1 minute.
LEARN
TRANSMIT/ LEARN
indi-
TRANSMIT/LEARN
indicator