Table of Contents
Advertisement
Using FM Mono
Using the Auto Source
Control
Turning Off the Display
Using Sleep
(Remote Control Only)
To receive FM stations in stereo, press
the display.
appears on the display when you receive an FM broadcast
STEREO
in stereo.
You can improve the reception of weak FM stations by pressing
appears. This reduces noise while you listen to a weak FM station, but
MONO
you get monaural instead of stereo sound.
The receiver can save two custom setups for rapid recall. Each setup includes a
program source, station (if the source is AM or FM), and surround mode.
Follow these steps to store the settings.
1. Select a program source and adjust the settings.
2. Press
AUTO SOURCE CONTROL MEMORY
scrolls across the display, then
3. While
MEMORY
flashes, press
receiver displays
MEMORY 1
To recall a setting, press
AUTO SOURCE CONTROL 1
with the stored setup. If the source is CD and you connected the CD player to
the
jacks, the CD player turns on and plays.
CONTROL
You can turn the display off so it does not bother you in a darkened room. Press
DISPLAY OFF
.
Press
again or press any button to restore the display.
DISPLAY OFF
The sleep function lets you set the receiver to turn off after 90, 60, or 30 min-
utes. To start the timer, set
until the desired turn-off time appears. To cancel the timer, repeatedly press
until the sleep time disappears from the display.
SLEEP
Basic Operation
until
FM MONO
.
AUTO SOURCE CONTROL
MEMORY
flashes.
AUTO SOURCE CONTROL 1
(or
) and stores the settings.
2
AUDIO/VCR
to
AUDIO
. Then repeatedly press
MONO
disappears from
until
FM MONO
(or
). The
2
or
. The receiver turns on
2
SLEEP
17
Hide quick links:
Advertisement
Table of Contents
