Advertisement
3. Static IP Address Configuration
You can manually assign an IP address to the unit and enter related network settings. Consult the
LES290A User Guide for further details.
To assign an IP address manually:
1. On the main menu, click Network.
2. Select Use the following IP configuration.
3. Enter the following (as necessary):
IP Address
Subnet Mask
Default Gateway
4. When you are finished, click the OK button.
5. On the main menu, click Apply Settings.
4. Setting up a Point-to-Point or Stand Alone Configuration
If your Serial to QVHD connection will be point to point, through a single Ethernet crossover cable,
pick an IP address for the LES290A Serial Server that is the same as the QVHD IP address,
except for the last number, i.e. 192.168.1.199.
192.168.1.200 is the factory default IP address for the QVHD.
You could choose:
IP Address
Subnet Mask
Default Gateway
See Figure 4.
Server Settings & Host List Menus
Nothing needs to be changed from default on the Server and Hostlist pages. . Consult the
LES290A User Guide for if you have special requirements.
RGB Spectrum, Inc.
Rev. 1 - 8/12/08
192.168.1.199
255.255.255.0
192.168.1.1
QuadView HD – Serial Server Set-up
If DHCP is not used to assign IP addresses, enter
it manually in decimal-dot notation. The IP address
must be set to a unique value in the network.
A subnet mask defines the number of bits taken
from the IP address that are assigned for the host
part.
The gateway address, or router, allows
communication to other LAN segments. The
gateway address should be the IP address of the
router connected to the same LAN segment as the
unit. The gateway address must be within the local
network.
4
Advertisement
