Setting Up; Attaching The Table-Top Stand - Sony BRAVIA KDL-55HX700 Operating Instructions Manual

Setting Up

Attaching the Table-Top
Stand
~
• For best picture quality, do not expose the screen
to direct illumination or sunlight.
• If the TV is brought directly from a cold to a warm
location, or is placed in a very damp room, or is
placed in a room in which heating has just been
turned on, moisture may condense on the surface
or inside the TV. Should this occur, turn off the
TV and leave the TV off until the moisture
evaporates, and then the TV can be used. If you
notice moisture condensation between the glass
panel and the LCD, turn on the TV and the
condensation will evaporate after the TV has
warmed up.
1
Refer to the supplied Table-Top Stand
leaflet for proper attachment for some
TV models.
2
Place the TV set on the Table-Top
Stand.
3
Fix the TV to the Table-Top Stand
according to the arrow marks
guide the screw holes using the
supplied screws.
~
• If using an electric screwdriver, set the tightening
torque at approximately 1.5 N·m {15 kgf·cm}.
4
GB
Adjusting the viewing angle of
the TV (HX700 models only)
This TV can be adjusted within the angles
shown below.
1
Remove screw as
shown.
2
that
Lift up and tilt.
~
• To return to 0°, reverse the above procedure.
0º
4
Install screw into
the top screw hole
of the Table-Top
Stand.
3
Slide in.
6º