Advertisement
Warmer Drawer Stand-Alone Installation
Warmer Drawer Specifications
•
Product Shipping Weight (approx.) – 55 Lbs.
•
Voltage Rating – 120V / 450W / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 0.5 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
•
Amps @ 120V = 3.8 Amps
•
Recommended Circuit Breaker – 15 Amps
27" Warmer Drawer/ 27" Single
Wall Oven Combination Installation
Warmer Drawer / Wall Oven Combination Specifications
•
To support Wall Oven when using in combination with Warmer
Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base,
capable of supporting 200 Lbs. Do NOT use full base, since planks
are necessary to allow for proper air displacement.
FRIGIDAIRE®
USA
250 Bobby Jones Expressway
Martinez, GA 30907
•
•
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
•
•
FPWD2785K 05/09
•
Always consult local and national electric codes.
•
Full plywood base required, capable of supporting 100 Lbs.
•
Base must be level and cabinet front must be square.
•
Warmer Drawer can be used alone, or is approved to be used in
combination with any Frigidaire® Wall Oven. (Refer to Combination
Installation Specifications and drawing on this page.)
Warmer Drawer is approved to be used in combination with any
•
Frigidaire® Built-In Microwave and /or Electric Single Wall Oven.
Note: For planning purposes only. Refer to Product Installation Guide
1-800-FRIGIDAIRE
frigidaire.com
•
•
1-800-265-8352
frigidaire.ca
•
•
© 2009 Electrolux Home Products, Inc.
Warmer Drawer
on the web at frigidaire.com for detailed instructions.
FPWD2785K F
27" Electric
Specifications
subject to change.
Printed in the U.S.A.
Advertisement
