Toshiba GD-1150 Service Manual page 44

(2) Binary signals
NSF Non-Standard Facility
Informs that the receiving station (machine) has a non-standard facility.
NSC Non-Standard Facility Command
Command to transmit using the non-standard facility which is selected corresponding to
NSF (i.e., Polling etc.).
NSS Non-Standard Facility Setup
Command to transmit using the non-standard facility which is selected corresponding to
NSF or NSC.
CSI Called Subscriber Identification
Provides the telephone number of the called station. Used to check the identity of the called
station.
CIG Calling Subscriber Identification
Provides the telephone number of the calling station. Used to check the identity of the call-
ing station (Polling, etc.).
TSI Transmitting Station Identification
Provides the telephone number of transmitting station. Used to check the identity of the
transmitting station.
DIS Digital Identification Signal
Informs that the receiving station (machine) has a standard facility (G3/G2).
DTC Digital Transmit Command
Command to transmit using the standard facility which is selected corresponding to DIS
(i.e., Polling, etc.).
DCS Digital Command Signal
Commands to transmit using the standard facility which is selected corresponding to DIS or
DTC.
SUB Sub-address
Indicates that the FIF information is a sub-address in the domain on the call-in side.
SEP Select Polling
Indicates that the FIF information is a sub-address for the polling mode.
PWD Password
Indicates that the FIF information is a password for the polling mode in a reception.
Indicates that the FIF information is a password for transmission in a transmission.
CFR Confirmation of Reception
Informs that the FAX is ready to receive data.
FTT Failure to Train
Informs that the TCF signal has not received correctly and requests the re-training.
EOM End of Message
Informs that the the 1st page has been transmitted and there is the next page; command to
return to the beginning of the phase B.
MPS Multi-page Signal
Informs that the 1st page has been transmitted and there is the next page; command to
return to the beginning of the phase C.
EOP End of Procedure
Informs that a document has been transmitted and there is no more pages.
MCF Message Confirmation
A reply to MPS, EOM or EOP; informing that image signals have been received correctly
and the FAX is ready to receive data.
RTN Retrain Negative
Informs that a document has not been received correctly; requests for the retraining or
phase synchronization to receive the next page.
GD-1150/1151/1200/1201/1160/1260
DIALING/COMMUNICATION CONTROL
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 8