Advertisement
IMPORTANT: THIS PROCEDURE MUST
BE FOLLOWED TO ASSURE PROPER
INSTALLATION.
Drain
Hose
,
Clamp
Use new hoses and washers
that came with your Whirlpool
washer/dryer.
17
,
Move washer/dryer
close to final position. Put
"hook" end of drain hose
into laundry tub or standpipe.
Check for proper length of drain hose.
13.
coupling
washer
Insert a flat washer into
each
end of
the inlet hoses. Check that washers
are firmly seated in couplings.
DO NOT FORCE EXCESS LENGTH OF
DRAIN HOSE DOWN THE STANDPIPE. THIS
COULD CAUSE SIPHONING.
To prevent
the drain hose
from coming
off or leaking,
it
must be installed
per the following
instructions:
1, Wet the inside end of the drain hose
with tap water.
DO NOT USE ANY
OTHER LUBRICANT.
2. Squeeze
ears of clamp
with pliers to
open and place
clamp
over the end
of the drain hose.
3. While holding
clamp
open, work end
of drain hose onto drain connector
until drain hose is within
l/4 inch of
ribbed
stop.
4. When the end of the drain hose is
within
l/4 inch of ribbed
stop, position
clamp
on drain hose so that the
bottom
of the clamp
is l/4 inch from
the end of the hose. Release pliers.
Inlet valves are
Before
attaching
water
inlet hoses, run
water through
both faucets
into a
bucket.
This will get rid of particles
in
water lines that might clog hoses. Mark
which
is the hot water faucet,
19.
Attach
bottom
hose (inlet marked
"H")
to hot water faucet.
Attach
top hose
(inlet marked
"C") to cold water faucet.
Tighten the coupling
to the faucet
by
hand, then use pliers to make final
two-thirds
turn.
16
Open clamp
n
and slide over
"hook" end of drain hose
to secure the rigid and
corrugated
sections
together.
14.
Attach hose to bottom
inlet valve
opening
first, Then second hose to
top inlet valve. Tighten couplings
by
hand, then use pliers to make an
additional
two-thirds turn.
Numbers
correspond
to steps.
PANEL D
Advertisement
