Table of Contents
Advertisement
E.
Exhaust dryer
F.
Check operation
SURE CONNECT
Kits Make Installation Easy
Part #4396028
Kit Contains:
2- 4' vent sections with attached close elbows
1- Wall plate for close clearance installations
2- 4" clamps
.
Dura Safe and Sure Connect are Trademarks of Whirlpool, U.S.A.
Panel E
1.
Connect vent to dryer outlet using a 4" clamp.
If connecting to existing vent, make sure the vent is
clean. The vent must fit over the dryer outlet and
inside the exhaust hood.
Make sure exhaust vent is secured to exhaust hood
with a 4" clamp.
1.
Check that you:
did not skip any steps.
installed all parts.
properly installed dryer legs.
leveled dryer.
have secured all exhaust vent joints with 4" clamps.
have all the tools you started with.
2.
Plug power supply cord into
grounded 3-prong outlet.
Dura Safe
TM
Outlets, Tight Installations
TM
Vent Kit
Provides 4 1/2"
clearance between
dryer and wall
Snap-Lock fittings
Total kit length
8 feet
Additional vent can
be snapped between
sections for
longer runs
Swivel collar
wall connection
Telescoping
sections
Beveled edges
allow corner
installations
18"-29" : Part #4396011
Periscopes For Offset
Provides 2 1/2" clearance
between dryer and wall
2
Great for closet
installations
0"-18", 18"-29" or
29"-50" periscopes
include one male
snap-lock fitting,
one extra long
draw-band collar
0"-18" : Part #4396037
and one clamp
18"-29" : Part #4396011
29"-50" : Part #4396014
0"-18" Periscope
Use when vent outlets
overlap or are offset
Excess length can
be trimmed to fit
Part #4396037
18"-29" and 29"-50" Periscope
Sections separate,
fittings can face
same or opposite
Swivel collar
Extra long
band-clamp
for dryer
connection
29"-50" : Part #4396014
2.
Move dryer into final position. Do not crush
or kink exhaust vent. Make sure dryer is level.
3.
Read the Use and Care Guide to fully
understand your new dryer. Select a full heat cycle
(not the air cycle) and start dryer. After five minutes,
open dryer door. You should feel heat inside dryer.
If the burner did not ignite and you do not feel heat
inside the dryer, shut the dryer off for 5 minutes.
Then check that:
controls are set in a running or "On" position.
start button has been pushed firmly.
gas supply line shutoff valve is open.
Repeat 5-minute test. If dryer still does not operate
properly, check the following:
electrical supply is connected.
house fuse is intact and tight; or circuit breaker
has not tripped.
dryer door is closed.
If dryer makes an unusual noise, check that dryer is
level.
For more information,
or to easily place your
order, call
1
/
"
1-800-442-9991
2
To have your venting
professionally installed,
1-800-253-1301
for the nearest
authorized service
provider.
call
Advertisement
Table of Contents
