Whirlpool 4152821 Installation Instructions

Installation Instructions
for your new undercounter
TRASH MASHER* COMPACTOR
BEFORE YOU USE YOUR COMPACTOR
Be sure your compactor is properly installed in an appropriate level area
and a place suitable for the size, function and
protection of the compactor.
ELECTRICALREQUIREMENTS
Observe All Governing Codes and Ordinances
A 120-Volt, 60-Hz, AC only, 1 !%Ampere, fused electrical supply is required. (Time delay fuse or circuit breaker is
recommended.) It is recommended that a separate circuit serving only this appliance be provided.
DO NOT use
an extension cord.
RECOMMENDED GROUNDING METHOD
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUNDING PRONG.
3-PRONG
GROUNDING TYPE
WALL RECEPTACLE
For your personal safety, this appliance must be grounded.
This appliance is equipped with a power supply cord having a
3-prong grounding plug. To minimize possible shock hazard,
the cord must be plugged into a mating 3-prong grounding type
wall receptacle, grounded in accordance with local codes and
ordinances. If a mating wall receptacle is not available, it is the
personal responsibility and obligation of the customer to have
a properly grounded. 3-prong wall receptacle installed by a
qualified electrician. See figure 7.
FIGURE I
* Trademarks in Canada Used by Authority of Canadian Trademark Owner, WHIRLPOOL CORPORATION, U.S.A.
- IMPORTANT -
00 NOT REUOVE THIS INSTRUCTION SHEET UNTIL READY FOR INSTALLATION.
AlTEll COMPLETING THE /AfSTALl.ATIO/V, SAVE THESE lMSTRUCTKJMS FOH FUTURE USE.
1
Part No. 4152821