Table of Contents
Related Manuals for Vax Rapide Spruce V-022
Summary of Contents for Vax Rapide Spruce V-022
-
Page 1: Instruction Manual
Vax V-022(Q).qxd 23/8/06 11:47 Page 1 Vax Careline: 0870 6061248 www.vax.co.uk Please read carefully before using CARPET WASHER this cleaner. Always fully extend Vax Model Number: V-022/V-022Q the mains cable before use. Instruction Manual... - Page 2 7 Fixed brushbar 17 2 x Right and left base screws 8 Dirty water tank 18 1 x Middle base screw 9 Dirty water tank lid 19 3 x Nuts 10 Power cord 20 1 x Vax AAA Carpet Cleaner 750ml...
-
Page 3: Safety Information
Vax V-022(Q).qxd 23/8/06 11:47 Page 3 Safety Information 2. Safety Information 19. Turn off the switch before unplugging. 20. Use only CE-approved 13 amp extension cords. Non-approved extension cords may overheat. Care should be taken to arrange the cord so that FOR HOUSEHOLD USE ONLY. -
Page 4: Use & Function
HELPFUL HINTS FOR CLEANING CARPET: Fig.3/2 Only use Vax AAA Carpet Cleaner with this carpet washer. 3. Slide the handle down on to the unit. Place screw Do not oversaturate carpet with cleaning solution into the recess at the back and tighten (Fig.3/3). -
Page 5: How To Operate
Fig.5/4 5. How to Operate Cord Release NOTE: Only use Vax AAA Carpet Cleaner, using other cleaning solutions may cause excessive foaming. This may cause the float to shut off the carpet washer IMPORTANT: Turn off when emptying and filling the prematurely. -
Page 6: Emptying The Dirty Water Tank
Once the float is activated, empty the dirty water tank. If the tank does not appear full, turn off the power switch and wait for the float to settle. For best results use only Vax AAA Carpet Cleaner. Fig.6/4... - Page 7 Vax V-022(Q).qxd 23/8/06 11:47 Page 7 Emptying the Dirty Water Tank/Storage 5. Rinse the dirty water tank and filter thoroughly with 8. While making sure the dirty water tank is resting lukewarm (max 40ºC) water. Allow to air dry fully...
-
Page 8: Brush Removal
Vax V-022(Q).qxd 23/8/06 11:47 Page 8 Brush Removal & Replacement 4. Replace floating brushbar (Fig. 8/4). 8. Brush Removal & Replacement WARNING: To reduce the risk of injury from moving parts, unplug before servicing. Tool Required: Phillips screwdriver Fig.8/4 IMPORTANT: The plug must be removed from 5. -
Page 9: Troubleshooting
Solution: Review clean water tank installation. PROBLEM: Carpet washer won’t dispense solution Cause: The clean water tank is not installed properly. Solution: Review How to Operate. Cause: The carpet washer needs a service. Solution: Take it to service centre or contact Vax Careline. -
Page 10: Technical Specification
550W An answerphone is available out of these hours. Clean water tank volume: 3.8 litres Any queries or concerns about using the Vax, call Dirty water tank volume: 2 litres the Vax Careline. Calls are charged at the UK Filters: Foam national rate. - Page 11 Vax V-022(Q).qxd 23/8/06 11:47 Page 11 This page has been intentionally left blank.
- Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the products V-022 Rapide Spruce / V-022Q Rapide Spruce Duo are manufactured in compliance with the following Directives: Safety: 73/23/EEC Low Voltage Directive EMC: 89/336/EEC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste.