Download Print this page

Vauxhall Movano Quick Reference Manual page 2

Hide thumbs Also See for Movano:

Advertisement

Vehicle features
Seat position adjustment:
Adjusting head restraint height:
1. backrest 2. Rear height
Raise the height of the head restraint to
3. Front height 4. Seat position
suit. The middle of the head restraint
should be at eye level.
Important: Do not sit nearer than 10
inches (25 cm) from the steering wheel to
permit safe airbag deployment.
Electrically adjustable
Electrically operated door windows 3:
exterior mirrors 3:
To operate incrementally, push top of
Turn switch to left or right to adjust the
switch to open and pull top of switch to
appropriate mirror.
close. Window stops when switch is
Lower aspherical mirrors must be
released.
adjusted manually.
To operate automatically 3 press or pull
switch for longer. Window will fully open
or close. Pull or press the switch again to
stop the movement.
Heated rear windows:
Demisting the windscreen:
Operate only with engine running.
Set the heater controls as shown above.
Pushbutton Ü on instrument panel.
Do not drive the vehicle until the
Press
=
on
windscreen is clear.
Press again
=
off
Control indicator on push-button
illuminates.
Turn off as soon as rear vision is clear.
The heated rear windows switch off
automatically after 10 minutes.
Fitting the seat belt:
Draw smoothly from inertia reel, guide
over shoulder and engage in buckle.
The belt must not be twisted at any
point. The lap belt must fit snugly across
the body. The seat backrest must not be
inclined too far back.
To release belt, press red button on belt
buckle.
Door windows:
The door windows can be operated with
the crank.
Air conditioning 3:
Press AC button
= on
Press AC button again = off
Once activated the air conditioning
system is operated via the normal
heating and ventilation controls.
In very hot temperatures, before starting
the engine, allow hot air to escape from
the vehicle by opening the windows.
Lighting switch:
Headlight range adjustment 3:
1. Horn 2. Headlights, side lights
Reduces dazzle for oncoming traffic.
3. Fog tail light and front fog lights 3
With dipped beam on, adjust the
headlight range to suit the vehicle load:
Pull stalk toward steering wheel to
change between main and dipped
No load
beam.
Max. load = 4
Headlight flash:
Pull stalk towards steering wheel.
Operating windscreen wash:
Windscreen wiper and wash with rain
sensor 3:
Pull stalk towards steering wheel
Move stalk downwards to operate wiper.
Wash fluid is sprayed onto the
Pull stalk to operate wash.
windscreen; at the same time the
K
=
Timed interval wipe or
windscreen wipers are operated for
automatic wiping with rain sensor.
several cycles.
Adjust the sensitivity rotate up more
sensitive, rotate down less sensitive
1
=
Slow
2
=
Fast
Return lever to its original position to
turn off.
Refuelling:
Warning:
In freezing conditions, wiper blades can
z
Use diesel fuel only
freeze to windscreen. Release blades
from the ice before starting the car to
z
Fuel tank capacity = 100 litres
(Bus models 70 litres)
prevent wiper motor damage.
z
Turn key anti-clockwise to unlock
filler cap
Operating turn signal lights:
Stalk in rest position
Right turn = Upwards
Left turn
= Downwards
When the steering wheel is turned back,
= 0
the stalk automatically returns to its
original position.
This will not happen when making a
minor steering manoeuvre such as
changing lanes.
When lane changing, move stalk to
resistance point.
When released, stalk will spring back.
Engine oil:
Check every 300 miles and prior to long
journeys.
Important: it is the owner's responsibility
to maintain the correct level of an
appropriate quality oil in the engine.
For engine lubrication, we recommend in
particular Vauxhall brand oils
ACEA A3/B4: SAE 10W-40 (without DPF):
AECA C3: SAE 10W-40 (with DPF):
or –
ACEA A3/B4: SAE 5W-40 (without DPF):
AECA C3: SAE 5W -40 (with DPF):
for petrol and diesel engines.
A higher quality than specified can
always be used.
When using commercially available
engine oils, the following are
appropriate for diesel engines:
only oil bearing the classification
ACEA B4/C3 is to be used.
Tyre pressures
(psi) - Full load
Tyres
Front
195/65 R 16C
215/65 R 16C
225/65 R 16C
205/75 R 16C
Rear
55
55
57
62
55
64
61
69

Advertisement

loading