Table of Contents
Advertisement
2 . I N S TA L L I N G D R I V E R S A N D S O F T W A R E
Windows XP/2000 Operating System
The driver is located on the provided floppy disk. Insert the floppy disk into the floppy disk drive and click
Browse.
Most floppy disk drives are configured as [A:]. Choose the [A:] drive in your browser and the
Si3112r.inf file for the SiI 3112. Select the file and click Open:
Verify that the directly listed in this window is A: and click OK.
Now, a window verifying that the new Driver for the board has been properly installed. Click Finish.
It is always good to Restart the computer after an installation.When asked to do so, Click Yes.
To install SATARaid, use Windows InstallShield by performing the following:
1. After computer restarts, insert cd in disk drive.
2. Double-click on Install SATARaid.exe.
3. Follow on-screen instructions to complete installation. Note: Do NOT install in the Start Up
folder. Choose the Default folder (normally Accessories or Administrative Tools or some-
thing similar).
Windows NT Operating System
The driver is on the provided floppy disk, insert the floppy in the floppy disk drive and click Have Disk.
The next window is asking for the location of the driver. Most floppy disk drives are configured as [A:].
To verify, click on Browse.
The next window verifies that the appropriate file is located on [A:]. Select the file Oemsetup.inf and
click Open.
[A:] should appear in the window. Click OK.
The next window allows you to select which driver to install. Only one driver should appear in this win-
dow. Select SiI 3112 Raid Controller and click on OK.
It is always good to Restart the computer after an installation. Click Yes.
SATARaid Manual - Rev. 0.92
P R E L I M I N A R Y
2-1
Advertisement
Table of Contents
Need help?
Do you have a question about the SataRaid and is the answer not in the manual?
Questions and answers