Related Manuals for Campbell HUB-SDM5
Summary of Contents for Campbell HUB-SDM5
- Page 1 HUB-SDM5 7/04 C o p y r i g h t ( c ) 2 0 0 4 C a m p b e l l S c i e n t i f i c , I n c .
- Page 2 Warranty and Assistance The HUB-SDM5 is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for twelve (12) months from date of shipment unless specified otherwise. Batteries have no warranty. CAMPBELL SCIENTIFIC, INC.'s obligation under this warranty is limited to repairing or replacing (at CAMPBELL SCIENTIFIC, INC.'s option) defective products.
-
Page 3: Table Of Contents
HUB-SDM5 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to specific sections. 1. Introduction..............1 2. HUB-SDM5 Specifications ..........1 3. General .................1 4. Installation and Wiring ..........1 4.1 Wiring SDM Devices ................2... - Page 4 This is a blank page.
-
Page 5: Introduction
The wires are secured to the terminal by a spring-loaded guillotine. 4. Installation and Wiring A U-bolt is used to mount the HUB-SDM5 to a 1.25 inch NPT pipe. The spring-loaded guillotines are opened with a small flat blade (2.5 X 50 mm) screwdriver (p/n 8125). -
Page 6: Wiring Sdm Devices
For the cluster of four wire ports located on the left hand side of the HUB-SDM5, the guillotine release slot is located to the right of the wire port. For the wire ports on the right hand side of the HUB-SDM5, the guillotine release slot is located to the left of the wire port. -
Page 7: Wiring Sdi-12 Devices
SDM Enable SDM Ground SDM Shield FIGURE 2. HUB-SDM5 terminal strip connecting four SDM devices to a datalogger. 4.2 Wiring SDI-12 Devices Before connecting the SDI-12 signal/power cable to the terminals, strip the wire insulation back to expose ¼ inch of bare wire. Feed the cable through the bulkhead fitting. -
Page 8: Generic Junction Box
5. Generic Junction Box The HUB-SDM5 can be used as a generic junction box. In its default configuration, six, five conductor cables can be connected to each other. Three, ten conductor cables can be connected to each other by removing the jumper between the terminal strips. - Page 9 This is a blank page.
- Page 10 Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci.com Campbell Scientific Africa Pty. Ltd. (CSAf) PO Box 2450 Somerset West 7129 SOUTH AFRICA www.csafrica.co.za sales@csafrica.co.za Campbell Scientific Australia Pty. Ltd. (CSA)