Cambridge Audio iD50 User Manual
Cambridge Audio iD50 User Manual

Cambridge Audio iD50 User Manual

Docking station for ipod

Advertisement

+

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iD50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Cambridge Audio iD50

  • Page 2: Table Of Contents

    Contents Introduction Introduction ................2 Important safety instructions ..........3 The iD50 enables you to get the very best audio and video Limited warranty ..............4 quality from your iPod. A ground sensing pseudo-balanced Rear panel ................5 noise cancelling scheme and buffered audio outputs extract the maximum information possible.
  • Page 3: Important Safety Instructions

    (89/336/EEC) Directives when used and installed according to this where they exit from the apparatus. instruction manual. For continued compliance only Cambridge Audio 11. Only use attachments/accessories specified by the manufacturer. accessories should be used with this product and servicing must be referred to qualified service personnel.
  • Page 4: Limited Warranty

    If your dealer is not equipped to perform the repair of your Cambridge Audio product, it can be returned by your dealer to Cambridge Audio or an Choose the installation location carefully. Avoid placing it in direct authorised Cambridge Audio service agent.
  • Page 5: Rear Panel

    To use the iD50’s on-screen display, and view video content, connect the iD50 to a TV/monitor using a suitable 75 ohm RCA/Phono cable designed specifically for Composite video. A higher quality alternative to the Composite connection, connect the iD50 to a TV/monitor using a suitable S-Video cable.
  • Page 6: Front Panel

    (two are supplied, new iPod models also come with a suitable new adaptor). To prevent damaging the dock connector, do not twist The iD50 is able to communicate with and control the the iPod when inserting it or removing it. following iPod models:...
  • Page 7: Remote Control

    Press to skip to the next playlist on the In either mode, to put the iD50 and iPod into Standby simply iPod (if you have created playlists). press and hold the button on the remote or the Play/Pause key on the iPod itself for about three seconds.
  • Page 8: Operating Instructions

    If you wish to use the iD50 for viewing videos or photos on idea to ensure the dock is in the correct video mode.
  • Page 9 For more information on settings, please see guide. Section Five below. Selecting this option will instantly play a random selection of The iD50 can be configured in a number of different ways to your iPod’s music. allow control of video settings, audio playback modes and charging.
  • Page 10: Technical Specifications

    Repeat Off (no songs are repeated). 100-240V ~ 50/60Hz 7.5V DC, 500 mA The iD50 docking station also charges the iPod battery while it is in the dock. However, the iPod’s battery charging circuit can introduce a little noise to the audio and video outputs.
  • Page 11: Troubleshooting

    For more frequently asked questions (FAQs), technical advice and information on getting the most out of your iD50, please visit the Support section on Cambridge Audio’s website: For all servicing, in or out of warranty, please contact your...
  • Page 12 Cambridge Audio is a brand of Audio Partnership Plc Registered Office: Gallery Court, Hankey Place, London SE1 4BB, United Kingdom Registered in England No. 2953313 © 2008 Cambridge Audio Ltd...

Table of Contents