Cambridge Audio Minx Air100 Setup Manual

Wi-fi set-up
To enjoy Airplay and internet radio, you must first
connect your Minx Air to your home network.
If you have a laptop computer, tablet, or any
other wi-fi enabled internet browser go to Step 1
below to connect to your home network.
If you have no wi-fi enabled internet browser
(such as a desktop computer) then please see the
online user manual for wired set-up instructions.
1
Connect the Minx Air to the mains power and press the power
button on top of the unit. Wait for up to 20 seconds for the
flashing light on the rear panel to flash green
2
Go to your computer and click on the
WiFi/network logo and select Minx Air_XXX.
Mac
iPad
3
Open a new page in your internet browser (Internet Explorer, Safari,
Chrome etc). In the address bar of your browser, type 192.168.1.1
followed by 'enter' and the Minx Air setup page will be displayed.
4
Select your home Wi-Fi network from the 'Service Set ID (SSID)'
drop-down list of choices.
Minx Air100/200 Wireless music system
5
Type your home Wi-Fi/Network password into the red box,
and click the 'Apply' button.
(Don't know your Wi-Fi password key? It's commonly found on
a label on your internet modem/router)
6
If you are happy that you have entered your details correctly, click
and orange
'OK' to finish.
The Minx Air set-up page may now display an 'error' or 'no data
received' type message. Don't worry, this is normal. You can now
close your internet browser.
7
After a few seconds, the Minx Air will be connected to your
network (successful connection is indicated by a solid green light
on the rear of the product). This can take up to 30 seconds.
(If your computer/tablet has not already done so automatically, change the
Wi-Fi/network setting on your computer/tablet back to your home network).
Airplay
PC
Congratulations! You are now ready to stream music via Airplay.
When you open iTunes or your Music you will see the
Airplay logo
playback device.
Note – when Minx Air is selected, it will take a few seconds
to connect.
Wait for the music to start playing before adjusting the volume.
allowing you to select your Minx Air as the
iPhone
iPad
Made a mistake?
To reset the Minx Air, press and hold the power button
and WPS button on the rear panel for 10 - 15 seconds
until the Minx Air switches off. Then start again at Step 1.
You can also watch the Minx Air connection videos on
the Cambridge Audio website for further explanation.
iTunes